Before beginning the installation process, determine the best locations for the mounting of the Mounting Bracket, Handset Cradle, Visor Microphone, Speaker and Junction Box. Consider the following guideline when planning the installation: * DO use all mounting hardware provided. * DO ensure that cables are not placed under stress. * DO follow proper + and ‐...
Speaker Installation Procedure 1. The Speaker includes a mounting bracket, permitting it to be mounted in a variety of ways. Loosen the thumbscrews on the side of the speaker and using the mounting bracket as a template, drill the necessary mounting holes and secure the bracket with the self‐tapping screws provide 2.
Mic. Speaker Cradle Privacy Handset Power Diagram 3 3. Route the cables out of the way to avoid physical or visual obstruction. Caution! The Hands‐free unit should be used with a negative ground system only. Power Cable Installation The power connector connection is as follows: BOTH Green need + 12 VDC...
8. Route and connect the green lead to a convenient ignition switch supply point in the vehicle. The green cable MUST be connected or the unit will not function correctly To Car Supply Voltage To Car Stereo To Car Stereo To Car Chassis Ground Diagram 5 Stereo Mute...
Page 7
Mounting of the cradle Installation of the Mounting Bracket and Clam Cradle Diagram 7 1. Remove the screw holding the top portion of the Mounting Bracket and separate the top portion of the mounting bracket from the bottom portion. 2. Retain position of this screw, as it will be needed to reattach the top to the bottom as described below.
Page 8
Inserting the portable phone into the cradle Diagram 8 Before inserting the phone into the cradle make sure to remove the connection cover from the bottom of the Iridium phone. Press the top of the phone back into the cradle until the catch mechanism of the release button snaps into place.
Installation of External Antenna 1. The antenna connection on the cradle has a TNC female connector that should be connected to a coaxial antenna cable properly terminated with TNC male. Please ensure that the appropriate cable is used for the length of the cable run and type of antenna. 2.
Page 10
3. A twenty (20) second countdown will begin on the Iridium handset and the dock will beep intermittently. 4. To cancel the distress call press the soft key labeled “CANCEL” on the Iridium handset before the counter reaches zero (0). Diagram 10 Emergency SOS Buttons hold simultaneously to engage.
Charging the battery 1. With the handset turned off, the car kit will charge the battery to 60% in approximately 1 hour. The charge time will be longer if the handset is operational during charge time. 2. For operator convenience, the handset’s backlight will remain on for ease of viewing during low/no‐light conditions.
Need help?
Do you have a question about the IRIDIUM 9575 and is the answer not in the manual?
Questions and answers