Before First Use; Using The Kettle - Sencor SWK 30WH User Manual

SWK 30WH / SWK 31GR / SWK 32BL / SWK 33OR / SWK 34RD

BEFORE FIRST USE

1 . Remove all wrapping material from the kettle and its base .
2 . Fill the kettle with clean water up to the maximum water mark . Boil the water and empty the
contents of the kettle . Repeat this process 2 to 3 times .
Note:
To boil water in the kettle proceed according to the instructions in chapter Using the kettle .
3 . Now the kettle is ready for use and for preparing warm beverages, etc .

USING THE KETTLE

1 . Set the desired length of the power cord . Push the power cord into the groove in the base . Place
the base on a stable, even and clean surface .
2 . Fill the kettle with the required amount of water . The water level must reach at least the minimum
mark (0 .3 l) and must not exceed the maximum mark (1 .5 l) . You may fill the kettle through the
spout or through the opening after lifting the lid . To open the lid, press button A4 . After filling
the kettle with water, close the lid A1 and push it down so that it is secured in the closed position .
Warning!
Never fill the kettle if it is located on the base .
If the kettle is overfilled, then boiling water could splash out .
3 . Place the kettle on the base A3 . Insert the power plug into the an electrical power socket . Check
that the lid of the kettle is closed .
4 . Start the kettle by moving the switch A7 to position I (On) . The power On light will illuminate .
Attention:
Do not turn on the kettle if it is empty . The incorrect use of the kettle may negatively affect its
lifetime . If you accidentally turn on the kettle without water, the thermostat will, after reaching
a certain temperature, interrupt the electric circuit and the power On light will turn off . The
kettle can be used again after several minutes, as soon as its stainless steel bottom has cooled
down .
5 . As soon as water boils the kettle will turn off automatically and the power On light will turn
off . Before taking the kettle off the base A3, check that it has turned itself off automatically .
If it has not automatically turned itself off, turn off the kettle manually by moving the switch A7
to position 0 (Off) .
Note:
The operation of the kettle can be interrupted at any time by moving the switch to position
0 (Off) .
6 . Pour the boiled water into a prepared container, cup or mug . Make sure that the kettle remains in
a horizontal position when it is carried, particularly if it is filled all the way up the maximum mark .
If you wish to open the lid to refill the kettle, first empty all the contents from the kettle so that
you are not scalded by the escaping steam .
7 . After you finish using the kettle, disconnect the power cord from the el . power socket . Empty the
kettle and allow it to cool down .
2015
Electric Kettle
SWK 35VT / SWK 36YL / SWK 37GG / SWK 38RS
EN-6
03/2015