Assemble the Height Rod …………………………………………….….. for approval prior to servicing or replacing. Selecting the Measurement Range ………………………………….….. Mounting the HTR-101 to the Wall ……………………………………… Serial Number Operation Instructions Your model and serial identification numbers are located on the back of the measurement rail and on the inside of the battery cover.
This operations manual contains instructions for installation and use of this replacement of defective parts or (at the discretion of Befour) the complete HTR-101. In order to achieve optimal results, the operator must read this replacement of the height rod or a related component.
Failure to comply with the following may void the warranty on the digital height rod. Height 57.5 inches (146 cm) To ensure proper operation of the Model HTR-101, this operator’s Width 2.2 inches (5.6 cm) manual should be reviewed carefully before operation. Keep this Depth from wall manual available for future reference and also for use in the orientation 0.5 inches (1.3 cm)
Befour immediately. Claims must be filed with the shipper as soon as possible after receipt of damaged goods. The display does not change while the headpiece is being raised.
At the same time the batteries are inserted, you may also select the desired display unit of measure format. Proper care and cleaning of the HTR-101 is essential to ensure a long life of accurate and effective operation. 1. Open the battery cover on the top of the headpiece.
Assemble the Height Rod 3. Have the patient stand under the headpiece. Position the rail, the headpiece, and the lower end cap. The lower end cap Lower the headpiece so it just will arrive with two small black phillips touches the crown of the head. screws partially tightened in the end cap.
Measuring Height Selecting the Measurement Range The HTR-101 has a 51” measurement span with which you may select the upper and lower measurement values. The only limitation is the upper value 1. Press and release the on/off button. can not exceed 90” or 7ft 6in.
Mounting the HTR-101 to the Wall 5. Raise the headpiece until it passes the reference dot and the “100.0” stops 1. Determine the location for the height rod. The ideal location will have flashing. sufficient space on the right side for the health care professional to stand as the display is on that side.
Calibration Calibration needs to be done prior to the first use. If the measurement 4. Lower the headpiece until its bottom silver surface is even with the 39-3/8” rail is ever removed from the wall and moved to a different wall location, it pencil mark you made in Step 1.
Need help?
Do you have a question about the HTR-101 and is the answer not in the manual?
Questions and answers