Assembly; Mounting Guide Bar And Chain - Shindaiwa 280TS Owner's/Operator's Manual

Mounting guide bar and chain

For your own safety, always stop the engine before performing any of the following
operations.
1. All adjustments should be made cold.
2. Always wear gloves when working on chain.
3. Do not operate with a loose chain.
NOTE
Move the chain brake lever (Front hand guard) fully rearward to remove or install the clutch
cover to the chain saw.
1. Release chain brake
2. A nut
3. Clutch cover
Install guide bar and chain as follows.
Unscrew a nut and remove clutch cover.
Mount the bar and slide toward clutch to make saw chain installation easier.
4. Guide bar
5. Clutch
6. Bar hole
7. Spiked bumper; option (Part number C304-000070)
8. Tension adjuster
9. Direction to tension the chain
Install saw chain as shown.
(Ensure cutters are pointing in the right direction)
Release the chain brake, and install the clutch cover (and spiked bumper; option) over
the guide bar stud.
Tighten the nut finger tight.
Ensure that chain tension adjuster fits into bar hole.
Hold the bar nose up and turn the adjuster clockwise until the chain fits snugly against
the underside of the bar.
A: Proper tension
B: Improper tension
Tighten a nut with the bar nose held up.
Pull the chain around the bar by hand.
Loosen the adjustment if you feel tight spots.

Assembly

WARNING
CAUTION
15