Related Manuals for KING KC-2102FXB
Summary of Contents for KING KC-2102FXB
- Page 1 21” WOOD BANDSAW MODEL: KC-2102FXB INSTRUCTION MANUAL COPYRIGHT © 2010 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
- Page 2 LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials.
-
Page 3: General Safety Instructions For Power Tools
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS 1. KNOW YOUR TOOL 12. ALWAYS WEAR SAFETY GLASSES. Read and understand the owners manual and labels affixed to Always wear safety glasses (ANSI Z87.1). Everyday eyeglasses only have impact resistant lenses, they are NOT the tool. - Page 4 COVER POSITIVE KNOB LEVER ROD LOWER DRIVE (QUICK CHANGE WHEEL SAW BLADE SYSTEM) MOTOR PULLEY LOCK KNOB AVAILABLE KING CANADA BLADES FOR YOUR BANDSAW MOTOR Model Blade Size TPI (Teeth/inch) KBB-2114-6 1/4” x 152-1/8” x .025” KBB-2138-6 3/8” x 152-1/8” x .025”...
-
Page 5: Electrical Connections
ELECTRICAL CONNECTIONS WARNING! ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE BANDSAW DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! POWER SUPPLY EXTENSION CORDS WARNING: YOUR BANDSAW MUST BE CONNECTED TO A 240V,... -
Page 6: Adjusting 90 Degree Table Stop
ASSEMBLY & OPERATIONS MOVING YOUR BANDSAW 1. Use a 2000kg. chain hoist connected to the top mounted hook (A) Fig.1 to move the Bandsaw to the desired location. 2. To ensure sufficient stability and security, bolt the base of the Bandsaw to the floor using the 4 mounting holes. - Page 7 ADJUSTMENTS & OPERATIONS RIP FENCE SYSTEM WITH RESAW GUIDE 1. Assemble the fixed base (A) Fig. 4 to the cast iron table using 2 hex. bolts and spring washers (B) Fig. 4. 2. Assemble the rear square tube (C) Fig.4 to the table using 2 cap screws.
-
Page 8: Changing Blades
ADJUSTMENTS & OPERATIONS CHANGING BLADES 1. Unplug power cord. 2. Remove the table insert and table pin from the table. 3. Open upper and lower wheel covers. 4. Loosen the upper and lower ball bearing blade guide systems. 5. Loosen the rod lever knob (A) Fig.7 (quick change saw blade system) on rear of bandsaw to quickly release blade tension. - Page 9 Fig.12. 4” Dust Collection hoses must be attached to the dust ports using 4” steel clamps and then connected to a Dust Collector. A variety of Dust Collectors are available from King Canada, see your nearest King Canada products retailer.
Need help?
Do you have a question about the KC-2102FXB and is the answer not in the manual?
Questions and answers