Advertisement
IFU 087.5
ADDITIONAL EQUIPMENT REQUIRED:
•
ELECTRIC HAND ROUTER
•
30mm ROUTER GUIDE BUSH
•
TUNGSTEN CARBIDE ROUTER CUTTER - 12.7mm DIA X 50mm (1/2" DIA X 2")
•
MINIMUM OF 2 QUICK ACTION, 'G' CLAMPS OR SCREW CLAMPS
Holder for
Edge of jig to cut
Slot for screw
flush fitting
indicator
clamp
location pegs
FACE 2
Slot for screw
Edge of jig to cut
Left & Right
clamp
indicator
Hand 45°
DE6289
For 500, 600, 616, 650. 700,
720, 740, 900 & 920mm Wide
Worktops
Carrying Handle
Rout recesses for Worktop
Connecting Bolts
Denotes Female
Denotes Male
FACE 1
Left & Right Hand
90° Joints
Position your worktop jig onto the laminate referring back to the instructions on 45° joints.
Subtract 293mm from the intended length - (this dimension is engraved on the jig and relates to
the distance from the bottom edge of the jig to where the edge of the cut will be).
E.g. 1000mm – 292 = 708mm
Position the worktop jig 708mm from the opposite end of the laminate you're cutting (see bottom
left diagram)
After the cut, a 1000mm length laminate is left.
Change the 1000mm figure used in this example for whatever length you require.
Page 2
Cutting to Length for 45° Joints only
When producing a male joint, left or
right handed and where the worktop
turns through 45°, the position of the
1000mm
cut jig has to be calculated. It is easier
if the female joint is cut first, leaving
the gap intended for the male part of
the worktop.
Example
The female joint has already been cut
(see left diagram) and the length of
the male worktop needed is 1000mm
(1 metre).
Page 15
Advertisement
