Table of Contents
Advertisement
CABINET
MOUNTING
Instructions
for Drilling
from Inside
If you cannot drill from the inside, go to
"Instructions
for Drilling
From Bottom"
1. Place Template 2 inside cabinet. Cut around
door jam and if necessary, corners to make
template fit.
(The front edge of template
must
be even with the front edge of the
cabinet.)Place
Template 2 in cabinet and
adhere it with scotch tape.
Note:For cabinets with a recessed shelf you
must measure the thickness of the front rail
and cut that amount off the front edge of
Template 2 using the template cut lines as a
guide. This will allow Template 2 to lay flat
on the shelf.
2. If you have a partition in the cabinet you
must do the following:
l
Cut Template 2 into two pieces to fit each
side to partition.
l
Adhere one piece of Template 2 inside
cabinet with scotch tape making sure that
front edge is even with the front edge of
cabinet.
l
Adhere Template 1 on front of the cabinet
with scotch tape so that the arrow is
aligned with the hole center line on
Template 2 (Fig. 10)
Fig. 10
METHOD
l
Position remaining piece of Template 2
inside cabinet and align the hole center
lines with arrows on Template 1 so that
distance from right hole center to left hole
center measures the distance indicated on
the template. (you will have to cut
excess
paper from the middle
of
Template
2 to make it lay flat.)
l
Adhere Template 2 inside the cabinet with
scotch tape. (Fig. 1 1)
l
Check again to make sure that the hole
center lines on Template 2 are straight and
that the distance from the right to left
drilling holes measures the distance
indicated on the template.
3. Go to "Drilling
the Mounting
Holes"
Instructions
for Drilling
from Bottom
1. If you have a front rail, measure the
thickness and cut that amount off the front
edge of Template 2 using the template cut
lines as a guide.
2. Adhere cut edge of Template 2 with scotch
tape against the back side of the front rail and
position it flat against the bottom side of the
cabinet.
-7
-
Advertisement
Table of Contents
