Hotpoint CSX20 How To Get The Best page 9

1. Remove food from shelf above
Sealed & Fresh Drawer and take out
shelf. Take food off the glass cover
and out of the drawer.
2. Put your fingers behind the
gasket at the rear of the drawer and
pull forward. Remove the gasket.
3. Pull the drawer part way out.
Reach in, push the rear of the glass
up; at the same time, push it back
until it clears front-corner retainers.
4. Tilt and remove the cover.
5. Pull the drawer forward, lift the
front to clear stops, and remove the
drawer. If the refrigerator door
doesn't open completely, pull the
drawer out until it hits the door.
Then lift the drawer UD until it is
higher than the drawe~ supports, tilt
it and take it out.
6. If tape holds Convertible Meat
the tape. Pull drawer partway out.
Reach in, push the rear of the glass
up and, at the same time, back, untd
it clears front-corner retainers.
7. Tilt and remove the cover.
After cleaning, replace in reverse
order.
When drawers and covers are back
in place, reinstall gasket at rear of
Sealed & Fresh Drawer. Fit the end
of the plastic drawer support into
the slot on the gasket, with the
rubber gasket flap facing you. Make
sure the gasket snaps into place.