Advertisement
DMX
When using an external DMX controller to control the unit, select the required amount of control channels using the
CHnd menu. When using several units with a DMX controller there are 2 options. Controlling several units exactly
the same. Make sure all units are set to be controlled from the same amount of channels (example 7ch, use the
CHND menu). Then set the DMX starting address required on each unit (example 001, use the addr menu). All
units must have the same starting address and all units will operate at the same time, with the same function from
the DMX controller.
Individual control of units
Make sure all units are set to be controlled from the same amount of channels (example 7ch, use the CHND
menu). Each unit will require its own individual DMX starting address. Set the DMX starting address on each unit
(example 001 on the first unit, 008 on the second unit, 16 on the third unit and so on). Ensure each channel is 7
channels apart from the previous one. No DMX channels should cross over (use the addr menu to set DMX
starting address). The value will change depending on the number of control channels selected in the CHnd menu.
XLR Wiring
XLR Pin configuration
Pin 1 – Ground
Pin 2 – Data compliment (negative)
Pin 3 – Data True (positive)
DMX protocol Menu
3 Channel
Channel
Function
Ch 1
Red dimmer 0-255
Ch 2
Green dimmer 0-255
Ch 3
Blue dimmer 0-255
5 Channel
Channel
Function
Ch 1
Red dimmer 0-255
Ch 2
Green dimmer 0-255
Ch 3
Blue dimmer 0-255
Ch 4
Master dimmer 0-255
Ch 5
Strobe 0-255 from slow to fast
7 Channel
Channel
Function
Ch 1
Red dimmer 0-255
Ch 2
Green dimmer 0-255
Ch 3
Blue dimmer 0-255
Ch 4
Master dimmer 0-255
Ch 5
Strobe / speed 0-255 from slow to fast
Ch 6
99 kinds colour selection when Ch 7 on 60-119
Ch 7
Dimmer (0-59), colour (60-119), jump (120-179), Fade (180-239), Sound active (240-255)
Advertisement
