Advertisement
Safety Instructions
Before installation, read these instructions carefully and completely. These installation instructions cannot cover every possible
installation, operation, or maintenance situation. Further information can be obtained from the product data sheets, which can be
obtained from Black Box Corporation.
This Power Distribution Unit (PDU) is constructed and approved in accordance with the safety requirements of IEC/EN60950 and
FCC emission standards.
Warning: Never work on the PDU if power is applied.
Before any installation, maintenance, or modification work, ensure that the power source is switched off and properly secured to
remain off. Touching any live components or improper handling of this PDU can result in death, severe personal injury, or substan-
tial damage to property. Safe operation is dependent upon proper storage, handling, installation, and operation.
Compliance with the relevant national regulations in the U.S., Europe, or other countries must be ensured. Before operation is
started, the following conditions must be observed:
• Connections to main power supply must be made in compliance with national regulations (NEC, NEMA, VDE0100 and
EN50178).
• When using stranded wires, all strands must be fastened in the terminal blocks (to avoid the potential danger of contact with
the enclosure).
• The power supply and main cables must be sufficiently fused.
• The degree of protection is I to IEC536. The non-fused protective ground connection must be connected to the Field Ground
Terminal.
• All output wires must be rated for the output current of the PDU, and must be connected with the correct polarity.
• The main socket-outlet should be installed near the equipment and should be easily accessible.
30-Amp Vertical PDU, 20-Outlet (18) IEC C13 & (2) IEC C19
Page 3
Advertisement
