Child Lock; Delay Start - Bosch SHS5AV5#UC SERIES Operating Instructions Manual

Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
1
Press the [On/Off] button.
2
Hold down the "A" button (see page 15) and press [Start] until the display indicates "d:00"
(x can be any number).
3
Release both buttons.
4
Press the "A" button until the display shows "r:05". NOTE: For models without a display, press the "A" button until the LEDs for
"Clean" and "Add Rinse Aid" are blinking.
5
Press the "C" button to select the desired setting.
"r:00" or 0 LEDs blinking = dispenser is OFF
"r:01" or 1 LED blinking = lowest setting
"r:02" = low setting
"r:03" or 2 LEDs blinking = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" or 3 LEDs blinking = highest setting
6
Press [Start] to save the setting.

Child Lock

NOTE; Only front-control models have Child Lock.
1
After starting a cycle you can activate the Child Lock.
2
Press and hold the C button until the display reads "CL " (models with display) or the "Child Lock" LED illuminates (mod-
els without display). NOTE: "CL" disappears from screen when button is released.
3
Child Lock is now active and buttons will not function, except On/Off.
4
To deactivate, press and hold the C button until the "Child Lock" LED turns off or "CL " disappears from the display.

Delay Start

For models with a display, you can delay the start of the cycle in one hour increments up to 24 hours. For models without a
display, you can delay the start of the cycle in three hour increments up to 9 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [Delay] button until the display jumps to "h:01" or the corresponding LED blinks.
3
Press the [Delay] button until the delay time corresponds with your requirements. For models with a display, the display
can be interpreted as follows:
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
To cancel delay start:
1
For models with a display, press the [Delay] button until "h:00" is indicated on the digital display. For models without a
display, press the [Delay] button until no LEDs are blinking.
2
Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
Cycle Completion Signal
1
Press the [On/Off] button.
2
Hold down the "A" button (see page 15) and press [Start] until the display indicates "d:00". Release both buttons.
17