Proper Installation And Location; Prior To First Time Use - Sylvania SE80070 Instruction Manual

PROPER INSTALLATION AND LOCATION

INSTALLATION
LOCATION
•
The water dispenser should be installed in an
environment where the temperature ranges
between 10ºC and 38ºC. Relative humidity
should not be higher than 90%
• Avoid direct sunshine
TIPS
•
If the dispenser is not going to be used for an
extended period of time, turn the switches at the
back to the 0 (off) position, unplug the power
cord and drain the remaining water

PRIOR TO FIRST TIME USE

IMPORTANT: Prior to using the Water Dispenser for the first time, the water tanks need to be flushed in
order to prevent the water from tasting awkward.
The water dispenser tanks also need to be cleaned periodically to prevent buildup of mineral deposits that can affect
water taste and flow. To clean the water tanks:
1. Make sure that the power switches are in the 0
(off) position
2. Mix one quart of water with either one quart of
vinegar or four ounces of citric acid crystals
3. Pour the solution in the opening at the top of the
dispenser
4. Press each dispenser button until water just
begins to flow from the tap
IMPORTANT: Before use, dispense one quart of water from each tap to make sure the cleaning solution is completely
removed.
•
The rear of the water dispenser should be at
least 10 inches / 25 centimeters from the wall to
allow for proper air circulation
•
Never place the water dispenser on paper or
foam, possibly causing an unstable condition
•
Do not place anything flammable besides the
water dispenser
•
In case the hot or cold water is not needed for an
extended period of time, turn the appropriate
power switch at the back of the dispenser to the 0
(off) position in order to save electricity
WARNING:
The dispenser should not be turned on
until at least 3 minutes have gone by since it was turned
off.
5. After about twenty minutes, press the dispenser
buttons until no more water comes out of the taps
and drain the hot water tank (see Draining the
Dispenser, page 7).
6. Reinstall the water bottle ( see Loading the
Dispense, page 6)
5