HELLER BFH6 Instruction Manual page 3

2.Correctly positioning 2.Correctly positioning
Well Ventilating
It is necessary of good ventilation around the refrigerator for easy
heat dissipation , high efficiency of refrigeration and low power
consumption. For this purpose, it is a must to leave enough
clear space around the refrigerator. The back is at least 100mm
away from the wall, both sides at least have a space of 100mm
separately and the height from the top is not less than 200mm.
A clear space should be left to open its doors to 160.
Power Supply
The refrigerator is only applied with power supply of single phase
alternating current of (220-240)V~50Hz; If fluctuation of voltage
in the district is so large that the voltage exceeds the above scope,
for safety sake, be sure to apply a.c. automatic voltage regulator
to the refrigerator. The refrigerator must employ a special power
socket instead of common one with other electric appliances.
Its plug must match the socket with ground wire.
Supply Cord
The cord should be neither lengthened nor folded into
coil during operation. Moreover, it is forbidden that cord
is kept close onto the compressor at the back of the
refrigerator, the surface temperature of which is very
high during operating. Touching it would deactivate
the insulation or cause leakage for electricity.
Protection from Moisture
Do not keep the refrigerator in a place where heavy
moisture is ,which can minimize the possibility of rusty
for the metal parts. Also, the refrigerator is forbidden to
be directly sprayed by water, otherwise, it is easy for
poor insulation and current leakage .
¡À ¡À
¡À ¡À
N N