Table of Contents
Advertisement
10. EXTERNAL SPEAKER JACK
You may add any 8-16 ohm external speaker. Simply plug your accessory
speaker into the jack. Inserting the 3.5 mm plug will automatically
disconnect the internal speaker.
11. ANTENNA CONNECTOR
A standard SO-239 type connector is supplied for attaching either mobile or
base antennas.
12. DC POWER CORD
To attach to power source.
13. MICROPHONE
The receiver and transmitter are controlled by the press-to-talk switch on the
microphone. To transmit, simply press in this switch. Release the switch to
receive. When tra,nsmitting, hold the microphone 3 to 4 inches from your
mouth and speak clearly at normal voice levels.
SP ECI F !CATIONS
GENERAL
1. Semiconductors
2.
Frequency Range
3. Mode of Operation
4.
Controls
5. Connectors and Jacks
6.
Speaker
7. Microphone
8. Power Supply
9.
Dimensions
10. Weight
— 5 —
: 19 Transistors and 15 Diodes
: 26965 MHZ — 27.255 MHZ
:AM
: Volume Control with power on-off switch
: Variable RF Gain Control
: Variable Squelch Control
Delta Tune Switch
Channel Selector Switch
: CB-PA Switch
ANL Switch
: Microphone Connector
: Coaxial type Antenna Connector
: Public Address Speaker Jack 3.5 MM
: External Speaker Jack 3.5 MM
: 3-1/2 inches, 8 ohms
: Dynamic Microphone (500 ohms)
13.8 VDC Positive or Negative Ground
: 7"(W) x 2-3/8"(H) x 7-11/16"(D)
:4 LBS..
Advertisement
Table of Contents
