Advertisement
Quick Links
Advertisement
Summary of Contents for Jumpking JumpPOD
- Page 1 JumpPOD WARNING YJ USA Corp., 3970 Lindbergh Drive Adison, TX 75001 www.jumppod.com 1-877-927-8777...
- Page 3 JumpPOD...
- Page 4 1. The owner and supervisors of the trampoline 13. Do not allow more than one person on the trampoline are responsible to make sure all the users are and inside the trampoline enclosure. Use by more than aware of practices specified in this manual. one person at the same time can result in serious injuries.
- Page 5 25. Do not attach anything to the barrier that is not a 35. While keeping the head erect, focus eyes on the trampoline manufacturer approved accessory or part of the toward the perimeter. This will help control bounce. enclosure system. 36.
- Page 6 Note: The JumpPOD JumpPOD...
- Page 11 sharply spot.
- Page 15 Make sure you understand the information in the box at the top of this page before you begin assembling the trampoline. POD-Connector T-Connector 2. Note: This step requires two persons. During this step, you will connect the six leg sec- tions.
- Page 16 3. Lay the Bed (10) on the ground inside of the assembled frame. Make sure that the two warn- ing decals (not shown) are on top of the Bed. Top Holes V-rings Frame Note: There are V-rings around the edge of the Bed (10) and holes around the top of the frame.
- Page 17 4. Lay the Frame Pad (9) on the frame. Double D-rings on the middle of pad should be fixed exactly on the right of each T-connector of frame. Enclosure Frame Opening Do not use the trampoline without the Frame Pad (9) , which is designed to reduce the likelihood of injury to the user from coming in con- Notches tact with the trampoline frame.
- Page 18 7. Using the included plastic tie, attach the Safety Placard (20) to the frame near the point where jumpers will climb onto and off the trampoline. The trampoline is now fully assembled. Make sure that all parts are securely attached. Familiarize yourself and all users of the tram- Frame poline with the safety precautions, use and...
- Page 19 10. Attach the other three Pole(13,14) in the same way. See inset drawing. Attach the Poles(13,14) as above arrow drawing 6 Sections Per Line shown. Top G4 Pole (19) 11. Lay out Top G3 Pole (19), joint each section Connector to a straight line as shown. Spread out G4 Pole and Joint each section to one straight line.
- Page 20 13. Note: During steps 14 and 15, you will “sew” the lower edge of the Netting(16) to the V-rings on the bed using the Cords(23). Locate the V-ring closest to the door. Thread one end of a Cord(23) through the lower edge of the Netting(16) above the V-ring and then thread the Cord through the V-ring.
- Page 21 Stake It is possible for the trampoline/enclosure be blown about by high wind. If you anticipate high winds, the trampoline/enclosure should be moved to a sheltered location, disassembled, or tied down to the ground with ropes and stakes (not included). At least three ropes and three stakes should be used.
- Page 22 (BLACK) Enclosure straight pole Top tube with T-connector(A & B marking) Enclosure top curve pole Top tube(A & B marking) Hemisphere cap Top tube with T-connector(B marking) (This part has been attached to the POD-Connector enclosure top pole(14)). T-Connector(Inserted into Top tube) Netting with attached Hardware Leg extension(A marking) Foam sleeve...