Summary of Contents for Groove GVWT02
- Page 1 Pro-Wave Long Range Two Way Private Radios Pro-Wave User Guide.indd 1 17/1/12 12:54:41...
- Page 2 Pro-Wave User Guide.indd 2 17/1/12 12:54:41...
-
Page 3: Display Screen
Pro-Wave Long Range Two Way Private Radios with twin charger Antenna Display Receiver LED - Displays the - Lights up when current channel You are receiving selection and other signals. radio symbols. Ear/Mic/ PTT (PUSH to Charge jack TALK) button - Press and hold PWR(POWER) to transmit. -
Page 4: Installation
2. Installation Belt clip 2.1 Removing the Belt Clip Unscrew the belt clip by rotating the screw anti- clockwise, using a screwdriver. See Figure 1. 2.2 Installing the Belt Clip Reposition the belt clip, then re-screw clockwise using a screwdriver, until the belt clip is Figure 1 Figure 2 fitted as in Figure 2 and locked... -
Page 5: Operation
Important: Always turn off the PMR units when charging. This will shorten the charging time. Main socket Charging the battery pack (using adaptor) Lift the charge socket cover located on the right side of the handset. Mic/spk jack Insert the round connector of the 9.0V DC/200mA adaptor Charge jack into the charge jack. -
Page 6: Important Safety Warning
Important safety warning Read these Safety Warnings before you charge the batteries. • To reduce radio frequency exposure when you are using your PMR, hold the unit at least 5cm (2 inches) away from your face. • Never use your PMR outdoors during a thunderstorm. •... - Page 7 4.4.2 Transmitting (sending speech) The unit is continuously in the Receive mode when the unit is turned ON and not transmitting. When a signal is received on the current channel, “RX” will be displayed and the receiver LED will light up. 4.4.3 Transmitting (sending speech) a.
- Page 8 a. Press the MENU button 5 times, “SC” icon will be displayed. b. Press the UP or DOWN button to begin scanning channels when an active signal is detected, channel scan pauses on the active channel. c. Press the MENU button six times, CTCSS flashes on the display, press the UP or DOWN button to begin scanning the CTCSS from 1-38.
-
Page 9: Auxiliary Features
5. Setting the Dual Watch Mode Your PMR is capable of monitoring two channels, the current and another (dual watch) channel. If the unit detects a signal on either channel, it will stop and receive the signal. a. Press the MENU button 11 times, “DCM” will be displayed while “OF ”... -
Page 10: Cleaning And Care
8. Safety CAUTION Damaged Antenna Do not use any PMR that has a damaged antenna. If a damaged antenna comes into contact with the skin, a minor burn may result. Batteries All batteries can cause property damage and/or bodily injury such as burns if conductive material such as jewellery, keys, or beaded chains touch exposed terminals. - Page 11 Pro-Wave User Guide.indd 11 17/1/12 12:54:51...
- Page 12 Issue 1 / Jan 12 Pro-Wave User Guide.indd 12 17/1/12 12:54:51...
Need help?
Do you have a question about the GVWT02 and is the answer not in the manual?
Questions and answers