Jfp1, Jfp2: Front Panel Connectors; Jci1: Chassis Intrusion Connector; Using/Resetting Chassis Intrusion Detector - MSI H170A GAMING PRO Quick Start Manual

JFP1, JFP2: Front Panel Connectors

These connectors connect to the switches and LEDs on the front panel.
1
JFP2

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the
chassis.
2. Close the chassis cover.
3. Go to BIOS > Settings > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
Press F10 to save and exit and then press the Enter key to select Yes.
5.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
Go to BIOS > Settings > Security > Chassis Intrusion Configuration.
1.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.
2
1
1 HDD LED +
3 HDD LED -
5 Reset Switch
7 Reset Switch
9 Reserved
1 Speaker -
3 Buzzer -
Normal
(default)
10
JFP1
9
2 Power LED +
4 Power LED -
6 Power Switch
8 Power Switch
10 No Pin
2 Buzzer +
4 Speaker +
Trigger the chassis
intrusion event
Overview of Components
19