Page 2
AirGateway Introduction ........................3 Setting AirGateway a station (client) to connect to your WiFi network ......4 Settings .......................... 5 Strana 2 z 9 Návod / rev.0...
Page 3
AirGateway is connected to the output jack RJ45 PoE power adapter. AirGateway unit can be combined with PoE power adapter for easier installation of LARA, because it is no longer necessary to resolve the supply of the Internet router or switch.
Page 4
AirGateway IP address 192.168.1.1 and confirm. Cable: PC permanently, set the IP address in the same range as the AirGateway (eg .: 192.168.1.2) using an Ethernet cable to connect to AirGateway. The startup screen. Fill your login information:...
Page 5
AirGateway 3. Settings Uncheck Quick Setup (Quick Setup Wizard), click Cancel. The initial setup screen, AirGateway. Strana 5 z 9 Návod / rev.0...
Page 6
AirGateway Open the NETWORK tab and set: Network Mode: Bridge Configuration: Advanced Managment Interface: BRIDGE0 Managment IP Adress: select DHCP DHCP Falback IP: enter the IP address of the gateway router to which you want to connect AirGateway DHCP Falback NetMask: enter the subnet mask (in most cases 255.255.255.0) Save the settings Change.
Page 7
(If you have more WiFi routers with the same network name (WDS), you need to determine which WiFi router will be set for theAirGateway to connect to. In the menu select the desired network and click Lock to AP save the MAC address. AirGateway will connect through the selected nearest WiFi router)
Page 8
AirGateway connects to the WiFi router and will be assigned an IP address to a DHCP server on your WiFi router. Note.: If you later want to change the settings, locate your AirGateway by MAC address in the settings of your router.
Page 9
AirGateway Power supply PoE + WiFi Strana 9 z 9 Návod / rev.0...
Need help?
Do you have a question about the AirGateway and is the answer not in the manual?
Questions and answers