Introduction MD-01 motion detector adopts delicate and modern design with intelligente analysis algorithm which effectively identify interference signal from body movement signals. This motion detector will not trigger the alarm when your pets (under 10kg) move inside your home, even if your alarm system is armed.
PCB Layout LJCELL Lithium Battery CR123A 3V 1300mAh L ED in dica to r I n fra re d se n so r Ta m pe r sw itch Infrared sensor: Detects the infrared rays released by human body motion. Do not touch the surface. Keep the surface clean. Tamper switch: When the alarm system is armed, the tamper switch will trigger the alarm if the case is opened.
Page 5
Installation Step 1: Fix the bracket on the wall with screws and attach the detector to the bracket. Adjust the bracket to change the detection distance and angle. It is recommended to mount the detector 1.8-2.5m from the ground. Step 2: Avoid installing the motion detector directly toward windows or near heat sources, such as heat extraction units, aircondition, micro-wave oven, refrigerator etc.
Detection Range 1 1 0° Top view Side view Test and Coding Set the alarm panel to coding status (please refer to the alarm panel manual), then trigger the detector by hand (or walking in front of the detector) to make it send wireless signal to the alarm panel for coding.