Table of Contents
Advertisement
REPAIR PROCEDURES
To replace the switch box:
1.
Remove the safety key.
2.
Slide the safety bail out of the switch box assem-
bly.
3.
Remove the motor cover by following the steps
describe in the motor section of this chapter.
NOTE: For safety reasons it is a good idea to
remove the fuse whenever the motor cover is
removed.
4.
Disconnect the battery pack and the motor.. See
Figure 3.7.
Figure 3.7
Motor connector
Battery
connection points
5.
Remove the two mounting screws using a T-27
Torx driver. See Figure 3.8.
6.
Unhook the harness from the clips on the handle
bar.
7.
Install the switch box assembly by following the
above steps in reverse order.
8.
Test run the mower before returning to service.
24
Mounting screws
Figure 3.8
Advertisement
Table of Contents
