Blomberg WNF 6100 WEN User Manual page 13

Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
completely.
Foreign substances left in the pump filter may
A
damage your machine or may cause noise
problem.
In order to clean the dirty filter and discharge the
water:
Unplug the machine to cut off the supply power.
Temperature of the water inside the machine
A
may rise up to 90 ºC. To avoid burning risk, filter
must be cleaned after the water in the machine
cools down.
Open the filter cap.
If the filter cap is composed of two pieces, press
the tab on the filter cap downwards and pull the
piece out towards yourself.
If the filter cap is one piece, pull the cap from both
sides at the top to open.
You can remove the filter cover by slightly
C
pushing downwards with a thin plastic tipped
tool, through the gap above the filter cover. Do
not use metal tipped tools to remove the cover.
Some of our products have emergency draining hose
and some does not have. Follow the steps below to
discharge the water.
Discharging the water when the product has an
emergency draining hose:
Refresh
Eco 20
(Freshen Up)
(Eco Clean)
On/Off
Start
Pause
Hand wash
Prewash
Wash
End
Machine
Lingerie
Mini (Daily
Care
express)
(Self Clean)
Coton
Synthetics
Woollens
Main wash
Rinse plus
Soaking
Child Lock
Cancel 3"
Temparature
Pull the emergency draining hose out from its seat
Place a large container at the end of the hose. Drain
the water into the container by pulling out the plug at
the end of the hose. When the container is full, block
the inlet of the hose by replacing the plug. After the
container is emptied, repeat the above procedure
to drain the water in the machine completely. When
draining of water is finished, close the end by the
plug again and fix the hose in its place. Turn the
pump filter to take it out.
Discharging the water when the product does not
have an emergency draining hose:
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill the
flowing water into the container you have placed in
front of the filter. Always keep a piece of cloth handy
to absorb any spilled water. When the water inside
the machine is finished, take out the filter completely
by turning it. Clean any residues inside the filter as
well as fibers, if any, around the pump impeller region.
Install the filter.
If your product has a water jet feature, be sure
A
to fit the filter into its housing in the pump.
Never force the filter while installing it into its
housing. Seat the filter into its place completely.
Otherwise, water may leak from the filter cap.
If the filter cap is composed of two pieces, close the
filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and
then press the upper part to close.
Mini 14
Half Load
Quick wash
(Super short
express)
Delicate
Intensive
Sport
Anti
Rinse Hold
No Spin
creasing
Time Delay
Drain
Super
13
EN
Darkwash
Mix
Hand wash
(Darkcare)
&
Silk
Shirt
Duvet
Hygiene
Spin
Cold
Ready
Super Eco
Rinse
Cotton Eco
Jean
Mini (Daily
express)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents