GE CV936 Owner's Manual And Installation Instructions page 18

11 INSTALL FILTERS
• Remove protective film covering the filters.
• Insert the filter into the "C" clips mounted to the top
of the vertical front panel.
• Tap the filter against one side to align with outside
opening.
• Pull the filter down into the lower slots at the bottom
of the filter support.
"C" Clip
Filters
• To remove the filters, grasp the handle, push the
filter up and pull forward.
Installation Instructions
Junction
Box
Filter
Support
18
11A INSTALL OPTIONAL
COMMERCIAL FILTERS
• Remove supplied filters (if installed).
• Place the filter drip trays into the horizontal channel
in the filter panel, located behind the filters. The
grease will drain from the filters into these trays.
• Insert the filter into the "C" clips mounted to the top
of the vertical front panel.
• Position the filter in the lower slots at the bottom of
the filter support.
12 FINALIZE INSTALLATION
• Refer to the operating instructions to test all
controls.