1. SAFETY WARNINGS Caution: risk of fire 1) WARNING―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. 2) WARNING―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. 3) WARNING―Do not damage the refrigerant circuit.
2. INSTALLATION 2.1 Location When selecting a position for your unit, please make sure the floor is flat and firm. The room should be well ventilated with an ambient room temperature between 61°F and 100°F. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
Page 5
5) Slide the door downwards and off the top hinge pin. Lift and remove door, place to side. 6) Remove the two screws from top bracket and transfer to the other side. You will need to first remove the plastic caps on the other side. 7) Slide the door back onto the top hinge, be sure the door is the right way up. 8) Screw the bottom hinge into place on the new side. 9) Place the foot on the other side. 10) Cover the top of door hinge with plastic cover by gently pushing into position. 11) Check that the door is aligned horizontally and vertically and that the seals are closed on all sides before final tightening of the bottom hinge. 12) Adjust the leveling feet as needed. 2.3 Door Space Requirements The unit's door must be able to open fully as shown. W×D≥35.5 in. × 31.5 in. 2.4 Levelling the Unit Adjust the two leveling feet at the front of the unit. If the unit is not leveled, the door and magnetic seal alignments will not be covered properly. 2.5 Cleaning Before Use Wipe the inside of the unit with a weak solution of bicarbonate soda. Then wipe with a “wrung‐out” ...
2.6 Before Using Your Unit Before placing any food in your unit, turn it on and wait for 24 hours to make sure it is working properly. This will also allow the unit to adjust to the correct temperature. Your unit should not be overfilled.
4. OPERATION 4.1 Adjusting the Temperature The temperature control knob is located on the right, below the freezer compartment. OFF = power off MIN = Warmest cool temperature setting MED = Normal operation (suggested setting for most situations) MAX = Coldest temperature setting During high ambient temperatures e.g.
5. CLEANING 5.1 Defrosting Frost may accumulate on the inner rear surface of the appliance, which will automatically defrost during the compressor cycle. Water is channeled via the drain hole to the drain tray above the compressor where it will evaporate. Please ensure the drain hole is checked and cleaned on a regular basis so water can exit the storage compartment.
7. Troubleshooting The following simple issues can be handled by the user. Please call the after-sale service department is the issues are not settled. 1. Unit is not plugged in. Check outlet and circuit. No power 2. Low voltage. 3. Power failure. 1.
slowly may lose quality or spoil. • Wrap foods properly and wipe containers dry before placing them in the refrigerator. This cuts down on frost build‐up inside the appliance. • Do not line the storage bin with aluminum foil, wax paper or paper towel. Liners interfere with cold air circulation, making the appliance less efficient. • Organize and label food to reduce door openings and extended searches. Remove as many items as needed at one time and close the door as soon as possible. 9. DISPOSAL Old units still have some residual value. An environmentally friendly method of disposal will ensure that valuable raw materials can be recovered and used again. The refrigerant used in your unit and insulation materials require special disposal procedures. Ensure that none of the pipes on the back of the unit are damaged prior to disposal. Up to date information concerning options of disposing of your old unit and packaging from the new one can be obtained from your local council office. When disposing an old unit, break off any locks or latches and remove the door as a safeguard. Correct Disposal of this product Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. ...
Need help?
Do you have a question about the FR-033RVBE and is the answer not in the manual?
Questions and answers