Ricatech RMC350 User Manual page 3

GUÍA DE SOLUCIÓN DE PROBLEMAS
PLATO
No hay alimentación
1. El adaptador de CA no está bien conectado.
2. Compruebe que el botón de volumen ENCENDIDO/APAGADO está en la posición ENCENDIDO.
No hay sonido
1. Compruebe el nivel de volumen girando el botón de volumen.
El plato no funciona
1. Asegúrese de que el selector de función está ajustado a "phono".
2. Pruebe a mover el brazo del tocadiscos hacia la derecha hasta que suene un clic.
3. Asegúrese de haber retirado la cubierta protectora de la aguja.
No se reproduce el CD
1. Asegúrese de haber introducido el CD correctamente (el lado del a etiqueta hacia arriba).
2. Compruebe que la superficie del CD está limpia
3. Asegúrese de que el selector de función está ajustado a CD.
USB - No se reproduce música si se pulsa REPRODUCCIÓN/PAUSA (USB).
1. Asegúrese de que la unidad Flash/dispositivo MP3 ha almacenado archivos de música.
2. La unidad solo reproducirá dispositivos Flash de hasta 4 GB.
3. Reinicie el USB/SD apagando o rotando el SELECTOR DE FUNCIÓN (2) para seleccionar otro modo.
Luego seleccione el modo SD/USB otra vez.
4. Compruebe si el/los archivo/s es/son archivo/s WMA. La unidad no reproduce el formato WMA, sólo
formato MP3.
Especificaciones USB
Interfaz
* USB2.0 Full Speed, host (no compatible con USB HUB)
Memoria Flash correspondiente
* Memoria Flash USB1.1
* Memoria Flash USB2.0 High speed
* Tamaño máximo de la memoria : 4 GByte
* Tamaño mínimo de la memoria : 512MByte (Solo FAT16).
Decodificador MP3
* Compatible con Audio MPEG 1, 2, 2.5
* Compatible con Layer 1, 2, 3
* Compatible con tasa de transferencia de Bit: 8 k ~ 320 kbps
* Subcarpetas anidadas: 8
* Compatible con tasa de muestreo: 8 k, 16 k, 32 k, 11,025 k, 22,05 k, 44,1 k, 12 k, 24 k, 48 kHz
* Número máximo de archivos para la reproducción: 999
* Formato de archivo para la reproducción: *.mp3. *.mp2, *.mp1; no es posible seleccionar el formato
38
POWER SOURCE
1 Untie the wire on the AC Adaptor
2 Plug the AC Adaptor into appropriate wall outlet.
3 Plug the small end of the adaptor into the ACADAPTOR JACK on the back of the unit.
UNPACKING THE TURNTABLE
1. Remove packing materials from unit.
Note: Save all packing materials.
2. Remove plastic bag covering radio.
3. Remove plastic safety cover from A/C plug.
4. Remove tie from A/C cord and untie antenna wire on back of radio
5. Open lid and remove styrofoam shipping material from turntable.
6. Remove black tie-wrap from under the tone arm.
7. Remove white protective needle cover by gently pulling towards the front of the unit.
8. Untie the FM antenna and allow it to hang down in a straight line for optimum FM reception. If you have
trouble tuning in an FM station, move the external FM antenna for best reception. Do no connect FM
antenna to outside antenna.
TURNTABLE OPERATION
Turn the unit on by rotating the ON/OFF-VOLUME ROTARY KNOB located on the front panel to the ON
position.
1. Rotate the FUNCTION SWITCH to select PHONO mode.
2. Set the SPEED CONTROL SWITCH to desire speed (33 1/3,45 or 78 rpm). Place the record on the
turntable.
3. Use the CUE LEVER to raise the tone arm off its rest. Pull the TONE ARM slightly to the right side until
hear the "click" sound to activate the turntable.
4. Move the TONE ARM by hand over the record and slowly lower it. Adjust the ON/OFF-VOLUME ROTARY
KNOB to the desired listening level.
5. At the end of the record, the TONE ARM will stop automatically. You must return to TONE ARM to arm
rest by hand.
Accessory: ADAPTER FOR 45 RPM
1 Place the 45 RPM adaptor over the spindle.
2 Gently place your 45 RPM record onto the turntable.
3 Follow the steps under turntable operation to play your record.
ANTENNA
For FM reception, the unit is provided with a FM WIRE ANTENNA , move the wire until the reception is
clear and with no interferences. For AM reception, the unit is provided with a directional build-in ferrite
antenna. Rotate the set to find the position in which the best reception is obtained. Do not connect the
EXTERNAL FM ANTENNA to any outside antenna.
RADIO OPERATION
1. Rotate the FUNCTION SWITCH to select RADIO mode.
2. Set the AM/FM BAND SWITCH to the desired radio band (AM or FM).
3. Select the desired radio station by rotating TURNING ROTARY KNOB.
4. Adjust the ON/OFF-VOLUME ROTARY KNOB to the desired sound level.
USB & SD-CARD OPERATION
SD-Card operation:
1. Insert SD-Card into the SD Card slot.
2. Switch on by turning the ON/OFF-VOLUME ROTARY KNOB from the Off position.
3. Adjust the ON/OFF-VOLUME ROTARY KNOB to the desired volume level.
4. Rotate the FUNCTION SWITCH to SD/USB Mode.
5. Press the PLAY/PAUSE BUTTON (USB/SD) to play the music tracks stored on the SD-card.
6. The green ACC LED will flash whilst the music is playing.
7. To pause the music, press the PLAY/PAUSE BUTTON (USB/SD) again.
8. Press the SKIP+ (USB/SD) / SKIP- (USB/SD) BUTTON to go to the next file during Play Mode.
9. To stop playing the music files stored on the SD-Card , press the PLAY/PAUSE BUTTON (USB/SD).
Note: Power the unit off first before disconnecting the SD-Card. Turning the VOLUME CONTROL to
Off position.
3