Subscribe to Our Youtube Channel
Summary of Contents for Orion Orion HCCA Competition
- Page 1 ©1999 Orion Industries, Incorporated 9235 S. McKemy Street , Tempe, Arizona 85284 Phone: 480.705.5600 Fax: 480.705.7339 One of the ADST family of companies. Part # 319-0730 REV B, 11/99...
-
Page 2: Declaration Of Conformity
Orion Industries Manufacturer’s address: 9235 S. McKemy Tempe, AZ 85284 declares, that the product: Product name: HCCA 5s Component Speaker System HCCA 6s Component Speaker System conforms to the following standards: EN 50 081-1/1992 EN 50 082-1/3.1995 European contact: Axel Perlwitz... -
Page 3: Table Of Contents
System planning Amplifier requirements Mounting locations Controls and connections Tweeter level control Midrange contour Connections to the amplifier Speaker wiring Speaker wire selection Polarity and phasing Termination Speaker mounting Woofer installation Woofer mounting Tweeter installation Surface mount Surface mount cup mounting... -
Page 4: Warranty Information
FEATURES OF YOUR HCCA COMPONENTS Molded woofer basket - The back bone of any good woofer is it’s basket. It provides the proper alignment and support structure for the magnet while the very thin braces guarantee a minimum of early reflections off the basket that would be ordinarily transmitted as sonic colorations through the cone. -
Page 5: Warnings And Tips
Make sure your radio/cassette/cd player and or other equipment is turned off while connecting 7 1/8” / 181mm the HCCA’s speaker terminals. Turn on the various components and slowly advance the volume 4 15/16” / 125mm control only after checking and double checking all connections 1 1/4”... -
Page 6: Amplifier Requirements
150 Watts per channel as a maximum so as not to exceed the thermal or mechanical limitations of the speaker system. Any amplifier between 20 watts and 100 watts per channel may be used. If you choose to use an amplifier with more power than 100 Watts be very careful, you can damage the speaker system if played too loud.The HCCA components produce reasonable... -
Page 7: Midrange Contour
12 gauge wire. Polarity and phasing The polarity - the positive / negative orientation of the connections - for every speaker and amplifier connection must be consistent so all the speakers will be in phase. When the polarity of one connection is reversed, bass output is reduced and stereo imaging is degraded. -
Page 8: Bi-Amplified Connections To Crossover Network
When installing the speakers drive the supplied sheet metal screws by gradually tightening them in turn. Drive the screws in until the speaker is well seated, but take care not to overtighten the screws. -
Page 9: Crossover Installation
CROSSOVER INSTALLATION Connecting the system Trim the speaker wire as needed. Strip no more than 1/4" (6mm) of the insulation from the ends. Twist the exposed strands thoroughly to prevent any loose strands from causing a short circuit. If possible “tin” the wire with a soldering iron. Either the tweeter or woofer input of each connector can be used when not bi-wiring/bi-amping (when the bi-wire/bi-amp jumpers are not cut, the tweeter and woofer inputs are connected in parallel). -
Page 10: Tweeter Installation
TWEETER INSTALLATION The HCCA speaker system is supplied with three different tweeter mounting options. Surface, flush and angled flush mount. After you have decided which option is best suited to your installation, refer to the following sections for specific details on mounting the tweeter.
Need help?
Do you have a question about the Orion HCCA Competition and is the answer not in the manual?
Questions and answers