Defrost Test - Sharp KB-3425LS Service Manual

KB-3425LS/K/W
KB-4425LS/K/W
PROCEDURE
LETTER
8. Reconnect all leads removed from components during testing.
9. Re-install the covers.
0. Reconnect the power supply cord after the cabinets are installed.
. Run the drawer and check all function.
D

DEFROST TEST

WARNING : The unit should be fully assembled before following procedure.
() Place one cup of water in the center of the turntable tray in the oven cavity.
(2) Close the door, touch the Stop/Clear (M) pad and touch the Defrost pad on the LCD. Then touch
the Steaks/Chops pad on the LCD. And touch the number pad 5 on the LCD. (Now, weight 0.5lb is
set.) And then touch the start pad on the LCD.
(3) The oven is in Defrost cooking condition.
(4) The oven will operate as follows
(5) If improper operation is indicated, the control unit is probably defective and should be checked.
E PROCEDURES TO BE TAKEN WHEN THE FUSE ON THE PRINTED WIRING BOARD (PWB) IS OPEN.
To protect the electronic circuits, this model is provided with a fuse added to the primary on the PWB.
. Fuse check and repairs.
) Disconnect the power supply cord, and then disassemble as per "OVEN/MICROWAVE DRAWER
DISASSEMBLY" page 40.
2) Open the drawer and block it open.
3) Discharge high voltage capacitor.
4) If the Fuse is blown, replace power unit.
5) Make a visual inspection of the varistor. Check for burned damage. If the varistor has been
6) Examine the touch control transformer with a tester for the presence of layer short-circuit (check
7) Reconnect all leads removed from components during testing.
8) Re-install the covers.
9) Reconnect the power supply cord after the outer case is installed.
0) Run the oven and check all functions.
2. Follow the troubleshooting guide given below, if indicator does not light up after above check and
repairs are finished.
) Disconnect the power supply cord, and then disassemble as per "OVEN/MICROWAVE DRAWER
2) Open the door and block it open.
3) Discharge high voltage capacitor.
4) Disconnect the leads to the primary of the power transformer.
5) Ensure that these leads remain isolated from other components and oven chassis by using
6) After that procedure, re-connect the power supply cord.
7) Follow the troubleshooting guide given below for repair.
TEST PROCEDURES
WEIGHT ST STAGE
LEVEL
0.5lb 60%
burned, replace the power unit.
the primary coil resistance which is approximately 60Ω ± 0%). If any abnormal condition is
detected, replace the touch control transformer.
DISASSEMBLY" page 40.
insulation tape.
COMPONENT TEST
2ND STAGE
TIME LEVEL TIME
20sec. 40% 20sec.
20
3RD. STAGE
LEVEL TIME
30% 45sec.