Yamaha YFM80RX Owner's Manual page 78

To check the engine oil level
1. Place the ATV on a level surface.
1
2. Check the engine oil level on a cold engine.
NOTE:
2
If the engine was started before checking the oil
3 level, be sure to warm up the engine sufficiently,
and then wait at least ten minutes until the oil set-
4
tles for an accurate reading.
3. Remove the engine oil filler cap, and then
5
wipe the dipstick off with a clean rag.
6
7
8
9
10
11
1. Engine oil filler cap
4. Insert the dipstick into the filler hole (without
screwing it in), and then remove it again to
1
8-10
check the oil level.
1. Dipstick
2. Maximum level mark
3. Minimum level mark
NOTE:
The engine oil should be between the minimum
and maximum level marks.
5. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
6. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
2
3
1