Audio Authority 980 Hookups And Settings

Model 980 System Module / 2- and 6-Channel Hookup

The System Module is essential for every Access
Control Panel or by Product Select Buttons or both, therefore, always follow this diagram for proper setup.
Concerning signal path, the Model 980EZ will be located just before the amplifier inputs (see Appendix A). In
the 2-channel configuration, the Front Inputs and Front Outputs are the only connections that are used. In the
6-channel configuration, all three sets of inputs/outputs are used. The Low-Level buses (e.g., front, rear,
sub) continue separately from the 980 on to their corresponding amplifiers or amp groups.

2-Channel Setup for 980EZ

6-Channel Setup for 980EZ

Sub Low-Level Out From Processor
Rear Low-Level Out From Source or Processor
Front Low-Level Out From Source or Processor
ASD
Phone: 859-233-4599 Fax: 859-233-4510
System Power
(connect 805-016 here)
Front Low-Level Out
From Source or
Processor
Tech Support USA and Canada: 800-322-8346 (Mon-Fri 8:30 AM to 5:00 PM Eastern Time)
Hookup drawings and FAQ http://www.audioauthority.com
™
system. It makes no difference if selection of product is by
System Bus
902 or 903
Connections
Control Panel
Connection
902
983
ASD
SYSTEM BUS
DC
System Module
POWER
SilenTouch™
POWER
LOW VOLTAGE
THEFT ALERT™
BUS IN BUS OUT BUS IN BUS OUT
A B
902
983
ASD
SYSTEM BUS
Model 980
DC
System Module
POWER
SilenTouch™
POWER
LOW VOLTAGE
SYSTEM RESET
THEFT ALERT™
BUS IN BUS OUT BUS IN BUS OUT
A B
701-1092
903
OR
Model 980
See page 30 for
instructions on
attaching remote
devices
THEFT ALERT™ RESET
POWER MODE
1
SPEAKER LIMIT
3
Set Parallel Speaker
4
SYSTEM RESET
Limit (see page 25)
BUS IN BUS OUT

System Reset Button

C
To Amplifiers
(Front Low Level In)
701-1092
903
OR
THEFT ALERT™ RESET
POWER MODE
1
SPEAKER LIMIT
3
4
BUS IN BUS OUT
C
To Rear Amplifier Group (Amp In Bus)
To Front Amplifier Group (Amp In Bus)
Optional
Theft Alert Setup
Output to 12V
Siren or
Output to store
security system
To Sub Amplifier
Group (Amp In Bus)
47