Advertisement
6. Camera Dimensions
7. Camera Description
1.
Lens Mount
This mount is used to install a CS-mount lens. CS-adaptor ring is required when using a C mount
lens.
2.
Camera Mounting Screw Holes
Screw hole for mounting the camera.
3.
Mount Adaptor
The adaptor can be attached onto the top or the bottom of the unit.
4.
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with DC control signal.
PIN NO.
1
2
3
4
5.
Video Connector
Connect to the long-term video monitor. (75Ω)
6.
IRIS Mode Selection Switch
Select DC or VIDEO mode according to the lens.
7.
OSD Control Buttons
ENTER button
UP & DOWN buttons
LEFT & RIGHT buttons
8.
Secondary Video Connector
Connect to the portable LCD for viewing on the spot. Designed for quick installation use. (75Ω)
9.
Power Input Indicator Light
When the camera is connected to a power supply, the indicator light will be on.
10. Power Input Terminal
Connect to the power supply.
© 2011 GVI Security; v5.09.11
All rights reserved. GVI Security makes no warranty of any kind with regard to this material, including but not limited to the documentation, function,
and performance of these programs and their suitability for any purpose. GVI Security shall not be liable for any errors contained herein for incidental or
consequential damages in connection with the use of this material. This document contains proprietary information protected by copyright. No part of
this document may be reproduced without prior consent of GVI Security, 2801 Trade Center Dr., Suite 120, Carrollton, TX 75007.
VIDEO
DC
DC + 12V
CONTROL -
NC
CONTROL +
IRIS
DRIVE +
GND
DRIVE -
6
Advertisement
