Use And Operation; Power Control; Mode Control - Honeywell MP08 SERIES User Manual

Hide thumbs Also See for MP08 SERIES:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION (CONTINUED)
IMPORTANT:
• The length of the exhaust hose is determined by the product specifications. Do not replace or
lengthen it as this could cause the unit to malfunction.
NOT RECOMMENDED
WARNING: Any warranties included with this product will be voided if an extra extension hose is added
to the originally provided installation kit or if the installation is performed differently than the manufactur-
er's instructions, without proper consultation. Please contact Customer Support for help with installation
procedures if needed.
The supplied exhaust hose has a diameter of 5 inches (12.7cm) and can be extended from 12 inches
to 47 inches (30cm to 120cm).
Do not bend (to the extent shown below) the exhaust hose. A bent hose will block exhaust air and
cause the unit to malfunction or shut-off.
Make sure the back of the unit is at least 50 cm / 20 inches away from the wall. Do not place the unit
in front of curtains or drapes as this could obstruct the airflow.
USE & OPERATION
TOUCH SCREEN CONTROL PANEL
CONTROL PANEL
(5)
(1)
(2)
(1)
Temperature and Time Setting Indicator Display
(1) Timer Control

(4) Mode Control

(7) Timer Light

POWER CONTROL

The Power Control turns the unit on and off. When
the unit is plugged in, this button lights up indicating
it is in a Standby Mode ready to be switched on
anytime.
• Cooling Mode
The unit works as an air conditioner. Adjust fan speed and air temperature to suit your desired comfort
level. Temperature setting range is 16°C- 32°C (61°F- 89°F).
• Heating Mode*
When heating mode is selected the indicator light will shine. Heating is activated only when the ambient
temperature is below 25°C (77°F). In this mode, the desired temperature can be set between 16°C- 25°C
(61°F- 77°F). Note: The air exchange hoses must vent outside the room when using heating mode.
(1)
(4)
(3)
(2)
(3)
(2) Fan Speed Control
(5) Power Control / Standby Mode
Mode Indicator Light
RECOMMENDED
(6) (7)
(2)
(3)
MODE CONTROL
4 settings: Cool, Heater*, Dehumidify & Fan.
3 settings: Cool, Dehumidify, Fan.
A light will indicate which setting is currently
being used.
Power Control
EN
4
50 cm / 20"
(3)
(3)
(3)
(4)
(5) & (6)
(4)
(5) & (6)
Receiving Sensor
(3) Timer / Temperature Set Controls
(6) Warning Light (when flashing)
Warning Light

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mn09chesMn09ceswwMn09chesbbMn09chesww

Table of Contents