Claris Water Cartridge; 11A. Installing The Cartridge - Capresso C3000 User Manual

• The machine is adjusted to hardness level 1 before it leaves
the factory. You can alter this setting as follows:
• The machine is on and the
• Open cover for programming buttons (Fig.1,19) and press
and hold the P button for approx. 3 seconds, until you hear
a beep.
• The will show PRESS KEY / POWDER QUANTITY
DISPLAY
+
• Press the button several times until the following
message appears:
DISPLAY
• Press the button. You will hear one beep.
P
• You can change the hardness level by pressing the
+
button until the desired level is displayed.
• Press the button once again to confirm. Another beep
P
will be heard.
• Press the button. The
N
• IMPORTANT: If you use the Claris cartridge (see chapter 11)
you can turn off the water hardness by setting it to position
"--".

11. CLARIS WATER CARTRIDGE

The C3000 comes with two free Claris water cartridges. The Claris
water cartridge is specially made for use with the Capresso C3000.
The Claris cartridge:
• Reduces the water hardness up to 75%.
• Removes (if present) up to 85% chlorine, up to 90% lead, up
to 95% copper and up to 67% aluminum.
13.
shows COFFEE READY.
DISPLAY
HARDNESS LEVEL 1.
will show COFFEE READY.
DISPLAY
• Cleans the water through an upward current principle (See Fig. 10)
just before the brewing cycle starts, ensuring freshly filtered water
every time you make coffee.
• Eliminates decalcifying the C3000. When using your Claris water
cartridge, you never need to decalcify your machine.
• Costs about 2¢ per cup. (Note: decalcifying costs about 1¢ - 3¢
per cup, depending on how hard your water is. The decalcifying
process takes about one hour.)
• Is available through your Capresso retailer or through Capresso
(mail order form or www.capresso.com, or call 1-800-220-5701).

11a. Installing the Cartridge

or
• Make sure the water tank is empty.
• Remove cartridge from its bag.
• Snap the Claris extension tube on top of the Claris cartridge (Fig. 11).
• Open water container lid and pull up the holder for Claris
cartridge (Fig.12).
• Insert the cartridge with its tapered end down and the
extension piece up. Make sure it fits snugly over the white
mesh piece inside the water container. Push down gently
(Fig.13).
• Close the holder for the cartridge so that it engages in the
water tank (Fig.12).
• Fill the water tank with fresh cold water and replace.
• shows COFFEE READY.
DISPLAY
• Open cover for programming buttons (Fig.1,19).