Screen - NABI NABI2-NV7A User Manual

Unable to Locate or Join a Nearby Wi-Fi Network
1. Verify that a network is available in Mommy/Daddy Mode by tapping All Apps Icon
Settings Icon
Wi-Fi is switched to On, then choose from the available networks listed. It may take a few seconds
for the Wi-Fi network names to appear.
2. Wi-Fi networks that are configured as private or closed do not display the network name on Wi-Fi-
enabled devices.
3. Join a closed or private network by tapping All Apps Icon
Add Network in Mommy/Daddy Mode. In nabi
Others. Enter the Wi-Fi network name, security and password.
4. Restart your Wi-Fi router by turning it off and then on again.
Weak Signal for Wi-Fi Network
1. Move closer to the Wi-Fi router to see if the Wi-Fi signal improves.
2. Tap the Browser Icon
signal improves.
3. Check for sources of potential interference: Using your microwave oven near a Wi-Fi signal may
cause interference. Check to see if your Wi-Fi network is near any power lines, power stations,
electrical railroad tracks, or other external electrical sources because these may cause interference
with your Wi-Fi connection.

14.3 Screen

Forced Reboot
In the unlikely event that your device becomes unresponsive, we recommend trying a forced reboot.
To perform a forced reboot: Hold the Power Button down until nabi turns off. When nabi is off, press
the Power Button to turn nabi on again.
Accelerometer Calibration
If you are experiencing issues with the screen orientation, you can reset the orientation sensor in
Settings in Mommy/Daddy Mode.
To reset the screen orientation: Tap All Apps Icon
Accelerometer calibration. Lay nabi on a flat surface, then tap OK.
Section 14 Troubleshooting and Support
> Wi-Fi. In nabi ™ Mode, tap Menu Key
in Mommy/Daddy Mode and try to load a webpage to see if the Wi-Fi
> Settings > Wi-Fi. Make sure that
> Settings Icon
™
Mode, tap Menu Key
> Settings Icon
>
> Wi-Fi >
> Settings > Wi-Fi >
> Display >
77