3. Fold the upper handle forward as shown in Figure 33.
Important: Route the cables to the outside of the
handle knobs as you fold the handle.
4. To unfold the handle, reverse the steps above.
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
3. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N-m).
4. Perform any needed maintenance procedures; refer to
Maintenance (page 14).
5. Check the engine oil level; refer to
Changing the Engine Oil (page 15).
6. Fuel the fuel tank with fresh gasoline; refer to
Filling the Fuel Tank (page 7).
7. Connect the wire to the spark plug.
G017313
Figure 33
19