Starter Pulley Disassembly; Starter Pulley Reassembly - Toro TC 1000 Service Manual

Recoil Starter Reel Reassembly (cont'd)
9. Release the slip knot by giving it a sharp tug.
Recoil Starter Starter Pulley Disassembly
1. Remove the nut securing the starter pulley to
the crankshaft. See Fig. 67.
RETURN SPRING
.
Figure 67
2. Remove the starter pulley by turning counter-
clockwise until it is completely unscrewed.
Be careful not to lose the washer.
3. Remove the "E" clip that secures the pawl to
the starter pulley. See Fig. 68.
Figure 68
Remove the pawl being careful not to lose the
5. Inspect parts for wear or damage and replace
return spring.
as necessary.
Recoil Starter
-
Starter Pulley Reassembly
1.
Install the return spring onto the pawl as
shown in Figure 69.
Figure 69
2. Insert the pawl and spring assembly into the
starter pulley hole marked "R". See Fig. 70.
Figure 70
3. Secure with an "E" clip. Check for free
operation of the pawl.
4.
Screw the starter pulley onto the crankshaft
by turning clockwise.
5. Place the washer on top of the starter pulley
and secure with the nut. Tighten to 0.8 to 1.O
kg m (70 to 87 in Ibs).
29