Toro 78357 Operator's Manual page 7

1
Figure 3
1. Clevis pin
4. Attach the pulley box if it is not already on the
tractor. Make sure the latches on the tractor's
front Attach- -A- -Matict are open (Fig. 4). Then
slide the pulley box into the Attach- -A- -Matict
latches and seat it.
5.
Close the latches.
7
6
2 2
Figure 4
1. Attach- -A- -Matict latches
2. Pulley box
3. Idler pulley
4. Belt tension release arm
5. Belt tension adjustment
knob
2
m- -3433
2. Hairpin cotter
3
1
6. Belt tension indicators
(one on each side)
7. Attach- -A- -Matict buttons
(one on each side)
Attach the Mower
1.
Ensure that the mower wheels are set for low
height of cut.
2. Ensure that the attachment lift is in the full up
position.
3. From the driver's right- -hand side of the tractor,
slide the mower under the tractor.
4. After sliding the mower under the tractor,
position it so that the slots in the side of each of
the mower's mounting brackets (Fig. 5) are
aligned directly below the tractor's attachment
lift arm.
1
5
1. Slots in the side mounting
brackets (2)
2. Belt guide
4
5. Start the tractor.
m- -3463
6. Lower the attachment lift arm fully and adjust
the deck's position until you can pull out on the
J- -pin of the lift arm and slide it into the slot in
the mounting bracket of the mower (Fig. 6).
7. On the driver's left- -hand side, pull out the
attachment lift J- -pin and slide it into the slot on
the other mower mounting bracket.
3
Figure 5
3. Front- -to- -rear adjustment
rod
Installation
2
m- -3460
5