Assembly; Install Handle - Toro 20050 Operator's Manual

Assembly

IMPORTANT: Do not connect extension cord to
mower until mower is fully assembled. Also, always
unplug extension cord from mower when adding or
switching attachments.

Install Handle

IMPORTANT: Control cable must be over, not under,
handles (Fig. 2).
CORRECT ROUTING
INCORRECT ROUTING
Figure 2
EN–5
POTENTIAL HAZARD
Excessive pulling on control cable may cause
mower to start. When mower is operating,
blade is rotating.
WHAT CAN HAPPEN
Contact with rotating mower blade could cause
serious personal injury.
HOW TO AVOID THE HAZARD
Do not lift mower by control cable or pull
excessively on cable.
1. Lift control cable above holes in rear of shroud.
2. Lower Handle – Slide ends of lower handle into holes
in shroud.
If handle stops before screw holes are aligned in center
of shroud openings, push down on lower handle
section while pushing tubes into holes in shroud (Fig.
3). Push tubes in until screw holes are centered in
shroud openings.
Secure ends of lower handle with two screws.
2420/2421
1. Lower handle
WARNING
1
Figure 3
2422