Using The Optional Rain-Freeze Sensor; Installing Indoor Mount Sprinkler Timer And Remote Control Device Sleeve - Orbit Manufacturing Fluid 57912 Manual

• Press
ON "X" MIN to water those stations for the desired
("X") number of minutes.
To Cancel Remote Control Device Operation
and Return Control to Timer:
• Press the
OFF/CLEAR button on the Remote Control Device.
This cancels any current commands from the device
and returns control back to the timer.
Section 5: Using the Optional
Rain-Freeze Sensor
An optional rain-freeze sensor can be purchased separately to
prevent programmed watering for a specified period of time
after rain falls or during periods when temperatures fall below
a specified temperature. The sensor has settings for RAIN,
and RAIN/FREEZE. Please refer to the manual that accompanies
the rain-freeze sensor for installation and programming instruc-
tions.
NOTE: The rain-freeze sensor will function only when the selection
dial on the timer is turned to AUTO.
Section 6: Installing Indoor Mount
Sprinkler Timer and Remote
Control Device Sleeve
NOTE: Before installation, please have the following tools on hand:
• Phillips screwdriver
• Wire strippers
1
07WTM002598 57926-24 rA.indd 12
Installing the Sprinkler Timer
in Five Easy Steps
1. Select a Location
Select a location with the following criteria:
• Near an electrical outlet. (Avoid using an outlet controlled
by a switch.)
• In a dry, indoor location, where operating temperatures
are not below ° or above 1° Fahrenheit (below 0
degrees or above 50 degrees Celsius).
• Not in direct sunlight.
• Accessible to sprinkler wires from valves.
OFF
ACTIVE BYPASS
SENSOR
Figure 3: Mounting the Docking Port
RF SYNC
Slide the Timer off the Docking Port
COM PUMP 1 2 3 4 5 6 7 8 9 10 11 12 24 VAC
2/16/07 2:07:23 PM