Adjusting The Time Correction (Tcr); Setting Defeat; Setting The Volume For Each Source; Adjusting The Caller Level - Alpine X109D Owner's Manual

Adjusting the Time Correction (TCR)

Before performing the following procedures, see "About Time
Correction" (page 37).
Setting item:
Time Correction
Correction mode
1
Touch the Correction mode button.
The pop up screen for selecting the correction mode is
displayed.
2
Touch [ms], [cm] or [inch] to select the mode for making
adjustments.
The selected mode is displayed on the Correction mode button.
3
Touch [ ] or [ ] for each speaker to adjust the time or
distance.
0.0 msec to 9.9 msec (0.1 msec/step)
0.0 cm (0.0 inch) to 336.6 cm (132.7 inch) (3.4 cm/step)
All speaker setting values are adjustable in the range of 15 ms or 510
cm.
4
To store the adjusted setting value, touch and hold
[Preset 1], [Preset 2], or [Preset 3] for at least 2 seconds.
• Touch [Flat] to set all values to 0.0.
• If the Rear Speaker setting is "Off, " the Rear Speaker setting cannot be
edited (page 32).
• If the Subwoofer setting is "Off, " the Subwoofer setting cannot be edited
(page 32).
Calling the Time Correction Value
Calling the pre-set time correction value.
Touch [Preset 1], [Preset 2], or [Preset 3] on the time
correction screen.
The setting stored in the Preset will be recalled.

Setting Defeat

If Defeat is "On, " MX HD, Equalizer Presets and Dual HD EQ functions
are turned Off. This disables any settings made for these functions.
Setting item:
Defeat
Setting contents:
Off / On

Setting the Volume for Each Source

Setting item:
Source Volume Setup Radio / SiriusXM / Compressed Media*
2, 3
iPod Music / iPod Video or AUX*
4
Factory Audio*
Setting contents:
-14 to +14
*1 Compressed Media is the music data in a USB flash drive (MP3/
WMA/AAC/FLAC).
*2 The item selected in AUX Source Select (iPod Video or AUX) is
displayed. For details, see "Setting the AUX Mode" (page 43).
*3 The source name set in "HDMI Setup" (page 44) and "Setting the
Auxiliary (AUX) Name" (page 44) is displayed.
*4 Not displayed when an iDataLink module is not connected.
• Settable source differs depending on the connected device and settings.

Adjusting the Caller Level

You can adjust the volume of the incoming call.
Setting item:
Caller Level
Setting contents:
1 to 11

Adjusting the Microphone Level

You can adjust the transmit volume, during the call.
Setting item:
Microphone Level
Setting contents:
1 to 11

Adjusting the Ring Tone Level

You can adjust the receive volume, during the call.
Setting item:
Ring Tone Level
Setting contents:
1 to 6

Volume Setting

You can change the volume of the sound heard when a button is
touched.
Setting item:
Key Sound Feedback
Setting contents:
0 to 6
1
/
3
/ DVD* / Bluetooth Audio /
35
-EN