Sec Button; Changing Oven Options - Bonn CM-1401T Owner's Manual

20sec Button

This function allows for instant heating at 20 second
increments at Hi power.
By repeatedly touching the 20sec button, heating time of up to
5 minutes at full power can be chosen.
1. Open the door and place food in the oven. Close the door.
• "HELLO" will show on the display.
2. Press 20sec button.
• Press 20sec button, " :20" shows in the display.
• The oven will start immediately. To increase heating
time by 20 seconds press 20sec button again. Up to 5
minutes heating time can be selected.
NOTE
The cooling fan will continue to run for 60 seconds to cool the oven down
after operation.

Changing Oven Options

Oven Options can be changed to suit individual preferences
according to the options table below.
1. Open the door.
• Display turns off .
2. Press and hold STOP button for 5 seconds.
• When the oven enters Oven Options mode, "CODE---"
will be displayed.
3. Enter the two digit code to activate the desired option.
For example, to turn off touch pad beeping, press 2
followed by 1.
4. Press START to save changes.
• To make further changes repeat steps 3 and 4.
Oven Options
Function Code Description (Factory default setting in bold)
CODE 1-0 3 long beeps for 3 seconds
CODE 1-1 1 short, 1 long beeps for 3 seconds
Changing Heating
CODE 1-2 3 second beep
Completion Sound
CODE 1-3 3 quick beeps for 3 seconds
CODE 1-4 5 quick beeps for 3 seconds
CODE 2-0 Touch pad beeps when pressed.
Turning Off
Touch Pad Beep
CODE 2-1 No beep when button is pressed.
CODE 3-0 The oven will beep when multi stage heat changes to the next stage.
Turning Off Multi Stage
Notifi cation Beep
CODE 3-1 No beep when multi stage heating changes to the next stage.
CODE 4-0 Maximum Heating Time is 60 minutes.
Adjusting Maximum
Possible Heating Time
CODE 4-1 Maximum Heating Time is 10 minutes.
CODE 5-0 10 preprogrammed settings available (0~9)
Changing Number Of
Preprogrammed Heating Choices
CODE 5-1 200 preprogrammed setting available (0~199)
CODE 6-0 Display will turn off after 1 minute.
CODE 6-1 Display will turn off after 2 minutes.
Adjusting Standby
Activation Time
CODE 6-2 Display will turn off after 3 minutes.
CODE 6-3 Display will turn off after 4 minutes.
CODE 7-0 Repeat function deactivated.
Repeat Function
CODE 7-1 Repeat function activated.
CODE 8-0 No END message after fi nishing heating cycle.
Activating Heating Completion
Message
CODE 8-1 Activation of "END" message after heating cycle.
CODE 9-0 The user may use preprogrammed buttons and manual time heating.
Deactivating Manual
Oven Operation
CODE 9-1 The user may use preprogrammed buttons only.
CODE 0-0 Clean fi lter message will show up for 24 hours every 90 days.
CODE 0-1 Clean fi lter message will show up for 24 hours every 60 days.
Clean Air Filter
CODE 0-2 Clean fi lter message will show up for 24 hours every 30 days.
Reminder
CODE 0-3 Clean fi lter message will show up for 24 hours every 10 days.
CODE 0-4 The oven will not display clean fi lter message.
5