Operation - Perel CCTVSET10 User Manual

Connecting the mouse
Plug the USB-mouse connector into the USB input [22] at the rear of the DVR.
•
Connecting external alarms / RS485
When desired, connect external alarm inputs (e.g. from door/window contacts) to the alarm input connector
•
[13].
Connecting ground
Connecting the ground terminal [14] to earth might resolve any image interference problems. Do not
•
connect when the image is fine.
Connecting the power supply
Plug a DC output connector of the included power adaptor into the 12VDC power input [15] at the back of
•
the DVR.
WARNING: only use the included adaptor.
Plug the included power cable into the adaptor input connector and plug the other end into the mains.
•
Switch to DVR on with the ON/OFF switch [12].
•
Connecting Local Area Network (LAN)
• Connect the DVR to a local network by plugging a network cable into the LAN port [21] at the back of the
DVR. Connector type is 8P8C (RJ45). Setup is done through the OSD.

7. Operation

Note: the functions, navigation and options of the DVR are accessible via the front panel, the remote control
or by using the mouse.
Switching on the DVR with the ON/OFF switch [12] at the back. It takes about 45 seconds for the
•
initialization to complete and to show live images.
After start-up, the power LED [6] is on and the display shows the 4 camera channels simultaneously. Date
•
and time is shown in the top area of the display. Should one of the images remain blank, check the camera
and cabling of that channel.
Press the LCD power switch [2] to switch the LCD screen on or off. This does not interrupt the recording
•
operation of the DVR!
Standby Mode
The system can also be put into standby mode. Power will remain to the system but recording is disabled.
To start/stop Standby mode:
• Press and hold the STANDBY button on the front panel [2] or remote control [A] until the
progress bar filled up completely. The system enters standby mode.
• Press and hold the STANDBY button on the front panel [2] or remote control [A] for ±3 seconds.
The system will power up again.
Password
ATTENTION: By default, passwords are disabled on the system. You do not need to enter a password
when accessing any system menu. However, for security purposes, it is highly recommended to
enable passwords on the system using the password menu. Refer to §7.3.4.
NOTE:
If there is no HDD in device, or the device can't read the HDD, or the HDD isn't formatted, a [H] is
•
displayed in the video preview interface.
The HDD in the DVR must be formatted before first use. Refer to §7.3.3.
•
7.1 General menu guidelines
Enter the menu of the DVR by either pushing the MENU-button on the front panel [4] or remote control,
•
or click the right mouse button, select 'MAIN MENU' and click left.
NOTE: If passwords are enabled on the system, you need to select your Device ID and enter the 6-digit
numerical password to open the Main Menu (see §7.3.4).
7.2 Screen image
Front panel controls:
•
Press the channel selector [2] repeatedly to scroll through the 4 channels or see all four channels
simultaneously.
Remote control:
•
Press on a numbered channel button (1~4) to see that channel full screen. Press the
the quadruple display.
26/05/2011
CCTVSET10
5
button to return to
©Velleman nv