Do you have a question about the VP18 and is the answer not in the manual?
Questions and answers
Jonathan
February 17, 2025
Have trouble keeping Door closed
1 comments:
Mr. Anderson
February 17, 2025
Check if the door is shut properly. If it is not, inspect the door seal and adjust it if needed. If the issue persists, contact an Authorized Service Provider for further assistance.
V series food holding, transport, and proofer cabinet (3 pages)
Summary of Contents for Vulcan-Hart VP18
Page 1
V SERIES FOOD HEATED HOLDING PROOFER CABINET MODEL: VP18 ML-138089 For additional information on Vulcan-Hart or to locate an authorized parts and service provider in your area, visit our website at www.vulcanequipment.com VULCAN-HART 3600 NORTH POINT BLVD. DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC BALTIMORE, MD 21222 www.vulcanequipment.com...
V SERIES PROOFING CABINET F-41190 (02-16) IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITYOF THIS OR ANY OTHER APPLIANCE.
V SERIES PROOFING CABINET F-41190 (02-16) GENERAL INTRODUCTION Vulcan-Hart Holding & Transport and It is suggested that you thoroughly read Proofing Cabinets are produced with this entire manual and carefully follow all quality workmanship material. of the instructions provided. Proper...
Page 5
V SERIES PROOFING CABINET F-41190 (02-16) Insert one (1) Water Pan in LOCATION: opening at the bottom of the For efficient cabinet operation, choose a cabinet and insert one (1) Water location that will provide easy loading Pan through slides underneath and unloading without interfering with the cabinet.
V SERIES PROOFING CABINET F-41190 (02-16) ELECTRICAL REQUIREMENTS ELECTRICAL CODES & STANDARDS: The cord and plug supplied is a suitable cabinet must installed durable cord with a molded three-prong accordance with: plug, and is provided with a proper strain relief. In the United States of America: State and Local Codes.
V SERIES PROOFING CABINET F-41190 (02-16) OPERATION CONTROLS The Cabinet and its parts are hot. Be very careful when operating, cleaning, or servicing the cabinet. THERMOMETER PROOF INDICATOR THERMOSTAT LIGHT HOLD INDICATOR LIGHT PROOF/HOLD FAN ON/OFF SWITCH SWITCH Proof / Hold Switch: Thermometer: Flip the switch upward for Proofing The Thermometer indicates the interior...
V SERIES PROOFING CABINET F-41190 (02-16) PROOFING OPERATING INSTRUCTIONS The Cabinet and its parts Always disconnect are hot. Be very careful when operating, power cord prior to adding water to cleaning, or servicing the cabinet. the water pan inside the cabinet. Do not over fill water pan with water.
V SERIES PROOFING CABINET F-41190 (02-16) DOUGH PREPARATION Hint: You may want to place the dough If Dough is Frozen: on a greased room temperature pan. Grease pan. Place frozen dough This helps shorten the proofing time. on pan and brush tops of dough Placing cold pans in the proofer brings with oil, cover dough lightly with a the temperature down inside the cabinet...
V SERIES PROOFING CABINET F-41190 (02-16) HOLDING OPERATING INSTRUCTIONS Switch the Fan switch to On if The Cabinet and its parts forced air holding is desired. The are hot. Be very careful when operating, use of the fan is optional. Use of cleaning, or servicing the cabinet.
V SERIES PROOFING CABINET F-41190 (02-16) CLEANING Allow warmer to cool before Always unplug cleaning. electrical power supply before Clean the interior of the cabinet cleaning. with a mild soap and water. The Cabinet and its Never use harsh chemicals or parts are HOT.
Drain hole clogged for Drip Pan underneath Cabinet SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, contact Vulcan-Hart Service Department at the address listed on the front cover of this manual, or refer to our website: www.vulcanequipment.com...
Need help?
Do you have a question about the VP18 and is the answer not in the manual?
Questions and answers
Have trouble keeping Door closed
Check if the door is shut properly. If it is not, inspect the door seal and adjust it if needed. If the issue persists, contact an Authorized Service Provider for further assistance.
This answer is automatically generated