Controls - Leev jack User Manual

Chapter 3.
USING THE CONTROLS
All controls are located on the two handlebars. On the
right side (display) you will find the main switch, battery
level indicator, speedometer and ODO meter. Further
on the right you will find the throttle, brake lever and the
horn. On the left side, you find the brake lever.
3-1: JACK handlebar
Main Switch / lock
To unlock your JACK and prepare it for riding, an RFID
switch is provided at the top of the display. With the RFID
tag your can switch the jack on/off, by holding the tag
onto the RFID spot.
JACK - User Manual JACK LJ 1.0 2015-1/INT EN
Battery level indicator
Fully charged, the JACK has a range of 25 Km. In this
situation, all 6 blocks of the battery will be visible on
the display. When the battery level drops, first the up-
per block will turn off than the one underneath that
etc.
Throttle
The throttle is the main control on the JACK and is
used to control the speed of the vehicle. Turn the
throttle with your wrist to go faster. Release the throttle
and and squeeze the brake levers to stop or slow. Do
not continue holding down the throttle while squeez-
ing the brakes as this can reduce battery life or cause
damage to your JACK.
Brake levers
The JACK is equipped with disk brakes on the front
and back, operated by two levers. Just like a bicycle
or motorcycle, the harder you squeeze, the harder the
brakes operate. Take time to get used to the braking
power before using the brakes at full speed. In certain
conditions, squeezing the brakes too hard at speed
could cause the operator or unit to lose control.
Horn
3-2: JACK display
The horn is situated at the right side. Use your thumb to
operate the horn (button).
Lights
The lights will automatically turn on when the JACK
is switched on. Please note that the JACK only uses
dipped beams and has no switch for high beams!
11