Installation - Garrard 401 Instruction Manual

Intermediate Wheel
The height of this rubber-tyred wheel in relation to the motor pulley
should be such that there is about
the tyre and an adjacent pulley step at any speed setting. If there is
not, slacken the three screws at the top of the motor pulley B and
raise or lower the pulley before re-tightening the screws equally.
Turntable Brake
This will bring the turntable to rest within 2 or 3 revolutions of switch-
ing off. If it continues to turn for a longer period slacken both screws
holding the brake pad lever E, on the underside of the base plate,
move the lever outwards slightly, then re-tighten the screws. The
action of the switch will be impeded if the brake is set too far out.
Power Supply Voltage Range
If this is altered, say from 220/250 volts to 110/125 volts, the two fol-
lowing adjustments will be required.
(1) After disconnecting the power supply and removing the volt
age changeover and connecting block cover, alter the posi-
tions of the wire links in accordance with Diagram 4.
(2) With the supply still disconnected, remove the neon lamp
below cover D, as instructed in the Installation section, and fit
a suitable replacement which is available from our Spares
Department. The reference numbers of both lamps are shown
in the spares list at the end of this manual.
1
/ (1 mm) clearance between
32 in
adjustments
diagram 4
9