Troubleshooting - Crosley ZDM6502AS Use And Care Manual

Clean the door gasket
Problem
Dishwasher won't start
Dishwasher beeps at the end of
the cycle
Rinse Aid light on
Dishwasher operates too long
Dishes are not clean enough
Dishes not drying enough
Spots and filming on dishes
Etching

Troubleshooting

Possible cause
Dishwasher won't start
Power supply or power line is not connected
Delay Start option has been selected
Child Lock activated
(selected models)
It indicates the wash cycle finished, the
dishwasher will beep
The rinse aid level is low
The dishwasher is connected to cold water
The cycle time will vary
The sanitize option is selected
Water pressure is temporarily low
The inlet water temperature is low
Dishes are loaded too close together
improper use of detergent
The selected cycle is not suitable for food
soil condition
One or more of the spray arms is blocked
Rinse Aid setting is too low or the dispenser
is low or empty
Improper loading of dishes
The cycle you chose did not include drying
Water hardness is too high
Improper loading of dishes
Old rinse aid is used
Rinse dispenser empty
Using too much detergent
The inlet water temperature exceeds 150 F
Shut the door completely,
Check and connect the power supply
Refer to Delay Start section in this manual to reset
Deactivate the child lock, refer to child lock
section in this manual
This is normal
Add rinse aid
Check the dishwasher, make sure it is properly
connected to the hot water supply
When heavy soil is detected, the auto, normal,
and Pots & Pan cycle will automatically increase
the cycle time
When sanitize option is selected, the cycle time
will be increased to meet the sanitized
temperature request
Use you dishwasher when the water pressure is
normal
Make sure the dishwasher is connected to the hot
water supply
Try not use your dishwasher when hot water is
being used elsewhere in the house
Load the dishes again as the manual
Add detergent depending on the water hardness
and the cycle you chose. Use fresh detergent
Choose anther cycle for longer washing time
Make sure the spray arms can rotate freely
Fill rinse aid dispenser or increase the amount of
rinse aid.
Load the dishes again as the manual instructs.
Choose the proper cycle with drying
For extremely hard water install a water softener
Load the dishes again as the manual indicates
Use fresh rinse aid
Add rinse aid to the dispenser
Use less detergent if you have soft water
Lower the inlet water temperature
17
Solution
make sure it is latched