Table of Contents
Advertisement
Note: Holding down the traction drive lever against the
handle engages the traction drive to both wheels.
Speed Selector Lever
Located on the main console panel (Figure 5).
The speed selector has 6 forward and 2 reverse settings. To
change speeds, release the traction drive lever and shift the
speed selector lever to the desired setting. The lever locks in a
notch at each speed setting.
Broom Angle Lever
Located on the right hand handle (Figure 5).
The broom can be locked into three positions; straight ahead,
or angled to the left or right 19°.
Specifications
Width
Length
Height
Weight
Engine rpm (no load)
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
118 cm (46.5 inches)
185.5 cm (73 inches)
105.5 cm (41.5 inches)
146.5 kg (323 lbs)
Full speed: 3600 ±100 rpm
Operation
Operating Instructions
Open the Fuel Shut-Off Valve
Move the fuel shut-off valve located below the choke, to the
right to turn on fuel.
Starting the Engine
1. On the right hand side of the engine, rotate the engine
On/Off switch clockwise to the On position.
2. On the rear left hand side of the engine, move the
choke lever to the left to the On position. On a warm
engine, leave the choke in the Off position.
3. Place the throttle midway between the Slow and Fast
positions located on rear right hand side of the engine.
4. Slowly pull the engine recoil handle until you feel
resistance and then stop. Allow the recoil handle to
return and then sharply pull it straight out. Allow the
rope to return slowly.
5. Allow the engine to warm up for several minutes, then
move the choke toward the Off position.
Stopping the Engine
1. Bring the unit to a full stop.
2. Place the throttle midway between the Slow and Fast
positions.
3. Allow the engine to run for a minimum of 15 seconds,
then turn the engine On/Off switch to the Off position
to stop the engine.
4. Wait for all moving parts to stop before leaving the
operating position.
5. Close the fuel shut-off valve by moving it to the left
when the machine will not be in use for a few days,
when transporting, or when the unit is parked inside a
building.
Driving the Machine
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking the Traction Cable (page 16) and
10
Advertisement
Table of Contents
