Set Information(Serial No & Model Name); Select Method Of Tool Option; Bar-Code Scanning - LG 50PT85 Service Manual

15. Set information(Serial No & Model name)
(1) Setting up like bottom figure (After setting white balance,
this is set)
1) Press ADJ Key in the Adjust remocon.
2) Select "System Control 2" by using
A
and press (ENTER).
3) Using Adjust remocon, RS-232 Host & Baud Rate &
Download value change (RS-232 Host:Gprobe, Baud
Rate:115200bps, Download:Cortez)

(2) Bar-code scanning

1) Push the menu button in DTV mode.
Select the STATION -> Diagnostics -> To set
2) Check the Serial Number.
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes

16. Select method of Tool option

(1) Press ADJ Key in the Adjust remote control.
(2) Select "Tool option 1" and "Tool option2" by using
D E
/ (CH+/-) key,
(3) TOOL OPTION1
(4) TOOL OPTION2
( Inch of model : "42,50" Applied module under the calassificatoin : )
6) After changing the Tool option1,2, push the EXIT Key.
- 12 -
A
(CH+/-) key, and press
1) Select "Maker" by using
the module maker and. applied module classification by
F G
using / (VOL+/-).
2) Select "Inch" by using
module according to the inch of model.
1) Select "TOOL NUM" by using
change the module maker and. applied module
classification by using
2) Select "FAN" by using
module according to the inch of model.
3) Select "DIGITAL" by using
the tool name according to the model.
Tool option1 Maker
2048 LGX4
2052 LGX4
Tool option2 Suffix
1665 KE*L(Y)LMP
1921 KE*L(Y)LMP
1665 KE*FLMP
(ENTER).
D / E (CH+/-) key, and change
D E
/ (CH+/-) key, and change the
D E
/ (CH+/-) key, and
F G
/ (VOL+/-).
D / E (CH+/-) key, change the
D / E (CH+/-) key, and change
Inch Tool
42 PT85
50 PT85
FAN DIGITAL AMP
0 1
1 1
0 1
LGE Internal Use Only
D E
/