Straight - ACE RC Seamaster ACE4527 Assembly Manual

Adhesives:
Instant setting Cyanoacrylate adhesive (thin CA)
Slow setting Cyanoacrylate adhesive (thick CA)
10 Minute Epoxy (fast)
20-30 Minute Epoxy (slow)
Zap-a-dap-a-goo, Shoe-goo or equivalent
Clear silicone seal
Tools:
Model knife,T-Pins
Small screwdrivers, Medium screwdrivers
Scissors
Steel straight edge
Long nose pliers and diagonal cutting pliers
Drill and drill bits
Fine felt tip pen and soft lead pencil
Straight building board
Heat sealing iron
Z-Bend pliers (optional)
R/C System:
4 Channel radio with 4 servos
Engine:
2 cycle: .40 to .46 CID
4 cycle: .50 to .60 CID
Propeller (appropriate for engine type and
preferred performance)
Radio - A 4-channel radio with four standard servos
is required.
RECOMMENDED TOOLS & MATERIALS
Adhesives - You will need two types of adhesives
for the Seamaster - Epoxy and Instant (cyanoacry-
late) adhesives. We recommend that you purchase
both 5-minute and 30-minute epoxy to cut down on
assembly time, but you can get by with only 30-
minute epoxy if time is not important.You will also
need a small bottle of both "Thick" and "Thin"
instant adhesive.
equivalent will also be needed.
Tools - Model assembly can be much easier if the
proper tools are used. Therefore, we have included
in our checklist to the left, a complete listing of all
the tools we used to assemble our prototype mod-
els. As you will notice, many household tools can be
utilized during construction.
Engine - The Thunder Tiger PRO-46 and F-54S are
the ideal engines for this airplane. These quiet-run-
ning engines are easy to start, require no special
break-in periods, are very easy to maintain and will
last for years.
3
Zap-a-dap-a-goo, Shoe-Goo, or