Terminating The Programme; Changing The Programme; End Of Programme; Switching The Dishwasher Off - Bosch SGI 58M05 Instructions For Use Manual

Keep pressing the timer programming
button until the required time is
displayed.
To delete the timer programming,
keep pressing the button until
is displayed.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when a figure
appears in the numerical
display .
3

Switching the dishwasher OFF

Several minutes after the programme has
ended:
Set the main switch
Turn the water tap off.
(Does not apply when Aqua-Stop unit
has been fitted)
Remove dishes, etc. when they have
cooled down.
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

Switch off the main switch
The lit display goes out. The programme
is saved.
If there is a warm water connection or if
the machine has already heated up and
the appliance door was opened, leave
the door open for several minutes and
then close. Otherwise, expansion may
cause the appliance door to spring open.
Switch on the main switch again.
Downloaded from DishWasher-Manual.com Manuals
to OFF.
1
.
1

Terminating the programme

(Reset)
Simultaneously press programme
buttons A and C for approx. 3 sec.
The numerical display indicates
The programme sequence lasts
approx. 1 min.
Switch off the main switch

Changing the programme

When the appliance is switched on, the
programme can be changed
within minutes.
If the programme is changed
subsequently, programme sections
(e.g. Cleaning) which have already started
run to the end. The new remaining time
consists of the remaining time of the
previous programme section and the
remaining time of the newly selected
programme.

Intensive drying

In the final rinse the appliance operates
at a higher temperature and therefore an
improved drying result is obtained.
(Caution if utensils are fragile!)
Close the door.
Hold down programme button A and
press main switch until
display illuminates.
Release both buttons.
The LED for button A flashes and
the digital display
3
setting (off) or
To change the setting, press
programme button A .
Switch off the main switch
en
.
.
1
the digital
1
displays the factory
(on).
.
1
17