Toro 22155TE Operator's Manual page 8

1. Higher handle position
Note: Torque all bolts to 120 in-lb (13.6 N·m).
3. Route the blade brake cable around the outside of
the handle and attach the cable end (Figure 6).
1. Blade brake cable
2. Insert cable jacket end
here
4. Route the self-propel drive cable around the outside
of the handle, thread the cable through the opening
on the left hand side of the housing, and attach the
cable end (Figure 7).
Figure 5
2. Lower handle position
Figure 6
3. Attach cable Z-fitting end
here
4. Throttle cable
1. Self-propel drive cable
2. Insert cable jacket end
here
5. Ensure that the self-propel drive is properly adjusted.
Refer to Adjusting the Self-propel Drive in the
Maintenance section.
6. Route the throttle cable around the outside of the
handle, insert the cable jacket in the cable clamp,
and attach the cable end to the throttle lever on the
engine (Figure 6 and Figure 8).
1. Attach cable end here
2. Cable clamp
7. Adjust the throttle cable by doing the following:
A. Set the throttle control to the Fast position
(Figure 9).
8
Figure 7
3. Attach cable end here
Figure 8
3. Throttle cable