Toro 51643 Service Manual page 58

Grip Removal (cont'd)
4.
Slide the grip assembly off the tube.
NOTE: The grip is located on the tube with a
plastic pin. The pin can be released by pulling or
prying down on the throttle control end of the grip
while sliding
it
toward the end of the tube.
It
may
help to lubricate the tube with soapy water prior to
this procedure. See Figure
111.
Figure 111
5. The ignition wire terminals may now be removed
from the end
of
the grip.
Grip Installation
1.
2.
3.
4.
5.
6.
Insert the switch wire terminals in the grip housing.
Slip the rubber grip over the control housing.
Lubricate the tube with a soap and water solution
and slide the grip assembly onto the tube until th
locating pin snaps into the hole in the tube.
(TC3000 and TC4000 only) Reinstall the engine on
the drive tube as described under Engine
Installation on Drive Tube, page 45.
Push the two ignition kill wires into the rear of the
grip.
It
does not matter which way they are
connected because they have the same polarity.
Mount the throttle control as described under
Control Installation on Drive Tube, page 46.
47